您要查找的是不是：
- thin-thick generalized conforming plate element 厚薄通用广义协调板单元
- Application of the method will also reduce the risk of having potentially Non Conforming Products (NCP). 运用这种方案还能减少潜在的不合格产品（NCP）的数量。
- The singularity of thick and thin plate element stiffness matrix due to the use of the reduced integration on the basis of the finite element is investigated. 本文研究了薄厚板壳有限单元统一性理论中，由于采用降阶积分而使得刚度矩阵产生奇异的问题。
- This paper put forwords one method to reahze the prepress of plate element by spit the plate element in the space of prepress where the beam element used. 提出通过在板单元里预应力分布位置分割板单元,连接梁单元,在梁单元里面施加预应力来实现板单元的预应力。
- Such non conformities shall be corrected by THALES Communications as soon as reasonably possible. 这种不符之处应由泰雷兹通信公司尽可能快的予以修正。
- Carrier Notice: You must confirm the items above, you have right to reject in case of non conformance. 运输者须知：你必须核对以上栏目事项，当与实际情况不符时，有权拒绝接受。
- THALES Communications shall make good within a reasonable time the non conformities and submit the corrected Equipment to acceptance as per the above mentioned procedure. 泰雷兹通信公司应在一段合理的时间内弥补不足之处，并将修正过的设备按照上述程序提交验收。
- The energy method was applied to analyze the restraining action exerted by adjacent plate element in the same section,which is called plate assembly effect(PAE) in the stage of postbuckling. 本文根据势能驻值原理,建立了均匀受压矩形管的大挠度弹性屈曲理论,用于分析屈曲后相邻板件间的相互约束作用,即屈曲后板组效应。
- An audit report will be issued at the end of the audit. This report contains the non conformities comments and a statement about compliance with the reference standards. 在审核结束出具一份审核报告。该报告包括对不符合要求事项的行为的评论,以及关于符合参考标准的一份说明。
- Consider the special quadrilateral element: right-angled trapeziod element.A kind of 12 freedom right-angled trapezoid plate elements are proposed. 摘要考虑特殊的四边形单元-直角梯形单元，构造出一类12自由度直角梯形板元；
- Based on tension-compression and bending equivalencies, an equivalent single material plate element was formed for bridge deck of composite girder with steel fiber reinforced concrete and steel. 基于拉压等效与弯曲等效方法,提出了钢纤维混凝土与钢结合梁桥面板换算为单一材料等效板单元的计算模式,导出了等效板单元的厚度和弹性模量的计算式。
- For an actual compos?ite girder bridge, three dimensional stresses were analyzed using the equivalent plate element, and the results of the analysis were compared with data from a load test. 基于拉压等效与弯曲等效方法,提出了钢纤维混凝土与钢结合梁桥面板换算为单一材料等效板单元的计算模式,导出了等效板单元的厚度和弹性模量的计算式。
- According to the properties of deformation and force of orthotropy plates in construction,a super element is set forward,that is the plate element with costalias. 根据构造正交异性板单元的变形和受力特征,提出了一种超级单元:带肋板单元,给出了这种单元的形函数及其单元刚度矩阵。
- His ideas do not conform with mine. 他的想法跟我的不一致。
- This non sequitur invalidates his argument. 他不根据前提推理因而论证无效。
- The thin plate elements, called MPS (Membrane Plate Similarity) elements, correspondent to the membrane CST, LST, Q4 and Q8 elements are given. 文中给出了对应于平面弹性膜单元CST、LST、Q4、Q8的薄板单元 ,我们称之为 MPS板单元。
- His ideas do not conform to mine. 他的想法和我的不一致。
- Conforming to accepted notions of good taste. 审美情趣的与普遍接受的良好品味相一致的
- Conforming to orthodox rules, as of procedure. 权威的遵守正统规则的，如程序规则的
- In this paper， the interpolations on a triangle under constraints are disscussed.By this method the 12-parameter triangle plate elements with error O(h2) are presented. 本文讨论三角形上在一定限制条件下的多项式插值问题，并将其应用于构造高精度双参数12参三角形板元.
以上内容独家创作，受著作权保护，侵权必究
海词词典，十七年品牌
